珠江三角洲4种淡水养殖鱼类重金属的残留及食用风险评价

为全面了解珠江三角洲淡水水产品中重金属污染现状,评估其生态风险与食用安全,于2014年8月至2015年8月采集罗非鱼、草鱼、乌鳢及鳜鱼主要养殖鱼类样品共计57份,采用原子荧光光谱仪(AFS),电感耦合等离子体质谱(ICP-MS)仪进行分析测定,并采用单因子污染指数(Pi)、重金属污染指数(MPI)、每周可耐受摄入量(PTWI)以及食入健康风险指标(Ri总)分别评估其污染程度、食用安全性与健康风险。结果表明,样品中Cr、Ni、Cu、Zn、As、Cd、Hg、Pb的含量范围分别为0.020~3.240,0.020~0.800,0.110~1.100,0.190~19.970,0.030~1.480,nd~0.606,0.003~0.118,0.040~0.803 mg·kg-1(湿重),Cr、As、Cd、Pb在水产品中超标率大小依次为As(7.0%),Pb(7.0%),Cd(5.3%),Cr(1.8%)。Pi结果表明,目前珠江三角洲养殖水域水产品中Cu与Zn残留处于正常范围内,Cr和Hg有少量样品为轻度污染,Pb、Cd与As存在重度污染样品,所占比例为2.86%、6.02%和5.74%。MPI结果显示不同水产品污染程度为乌鳢>鳜鱼>罗非鱼>草鱼,总体上各种水产品MPI依然处于较低的水平;食用安全性结果显示,目前成人每周摄入水产品是安全的,但乌鳢Cr,罗非鱼As含量较高分别达到PTWI的37.76%和19.51%,表明水产品中Cr、As残留可能存在一定的食用安全隐患。健康风险模型结果显示,所有样品均未超过国际辐射防护委员会(ICRP)的推荐的最大可接受水平(5×10-6a-1)。综合分析珠江三角洲淡水养殖主要水产品可知,其尚未出现明显的污染安全问题,但As与Cr等元素的潜在风险值得进一步关注。     

Producing biodiesel from waste animal oil by modified ZnO

Biodiesel produced by transesterification of waste animal oil is a promising green fuel in the future. ZnO-Al₂O₃ and ZnO/Zn₂Al composition oxides were prepared by co-precipitation method and impregnation method, respectively. The above catalysts were characterized by X-ray diffraction (XRD), Brunauer--Emmett--Teller (BET) and CO₂ adsorption and temperature-programmed desorption (CO₂-TPD) and show that the high activity for the catalyst is attributed to its high alkalinity. The reaction parameters were optimized and the results show that the transesterification ratio of waste animal oil can reach 98.7% with 10% ZnO/Zn₂Al catalyst after 2 h. Moreover, 10%ZnO/Zn₂Al compound oxides can be active for the successive cycles. The glycerol as a predominant by-product after transesterification is of high purity with high use value.     

The fate and risk of selected pharmaceutical and personal care products in wastewater treatment plants and a pilot-scale multistage constructed wetland system

The removal of 12 pharmaceuticals and personal care products (PPCPs) in two full-scale wastewater treatment plants (WWTPs) and a tertiary treatment system was studied. The ecological risks of effluents from both secondary and tertiary treatment systems as well as excess sludge were evaluated. Primary treatment and ultraviolet light disinfection showed limited ability to remove most selected PPCPs. The combination of an anaerobic process and triple-oxidation ditches can eliminate DEET better than the anaerobic/anoxic/oxic process. Adsorption to sludge played a key role in the removal of triclocarban. Multistage constructed wetlands as a tertiary treatment efficiently removed caffeine and ibuprofen from wastewater and could decrease the risk of partial selected PPCPs. Selected PPCPs residues in excess sludge generally produced higher risks to the ecological environment than effluents from WWTPs.     

污泥膜覆盖好氧发酵堆体流场模拟及应用研究简

运用Gambit软件建立了污泥好氧发酵堆体的多孔介质模型，通过自行设计的实验装置获得了堆体的通风粘性阻力系数和惯性阻力系数以及功能膜压差与透气量之间的关系，用Fluent软件分析了堆体不同截面形状及底部通风管数量对堆体通风均匀性的影响，为确定合理的通风管数量及截面几何形状提供理论依据。对上海奉贤区城镇污水厂污泥处理工程发酵仓进行堆体流场模拟，确定堆体采用小拱形截面形状，堆高2 m，宽8 m，底部设置4条通风管，实际运行效果良好。     

兰坪铅锌矿区不同污染梯度下优势植物的重金属累积特征

对兰坪铅锌矿区污染程度不同的3个样地(云南松林、魁蒿群落和马桑灌丛)进行植被调查,选择其中9种共有的自然生长的优势草本植物为研究对象,测定了土壤及植物体的重金属含量。结果显示,3个样地土壤Cu、Cd、Pb和Zn等4种重金属含量均表现为马桑灌丛>魁蒿群落>云南松林;植物体内重金属积累呈现出随着土壤污染程度增加而增加的趋势;所选择的9种植物均不符合超富集植物的标准,依据不同的耐性机制将9种植物分为3类,野棉花能较强吸收土壤中重金属,并转移到地上部分,属于富集型植物;西南金丝梅、倒提壶、长籽柳叶菜、魁蒿、翻白叶和四脉金茅吸收的重金属主要积累在根部,属于根部囤积型植物;尼泊尔蓼和中华山蓼体内重金属含量较低,属于规避型植物。讨论了利用这些植物进行矿山治理。     

The 2030 Agenda for Sustainable Development and China’s implementation

The concept of sustainable development has experienced great development and change at different levels of theoretical connotation and practical implementation since 1960s and 1970s when it was first proposed. People’s understanding of the relationship between economy, society, and environment has been continuously deepened over the years. When it came to the end of 2015, it is necessary to examine the results of the United Nations Millennium Development Goals on sustainable development, and at the same time, the post-2015 framework and guidance on sustainable development at the global level were to be made, including the ideas, action plans, key areas that would guide the global sustainable development. The 2030 Agenda for Sustainable Development has developed a 5P theoretical framework of being people-centered, global environmental security, sustained economic prosperity, social justice and harmony and partnership promotion, including a political declaration, 17 overarching goals and 169 specific targets, specific ways of implementation, as well as the follow-up. It is the road map to achieve global sustainable development and meet the requirements of the millennium development goals. This paper summarizes the understanding of the concept of sustainable development from its origin, its significant development, to the proposition and development of the 2030 Agenda for Sustainable Development, and its strategic impact on China.     

一种包埋微生物复合填料的制备及性能评价

采用包埋法制备出一种复合生物填料，测其各项理化性质，并以NO。模拟废气验证其脱硝性能。填料主要由碳酸钙、牛粪堆肥腐殖质、菌剂载体、水泥、轻质珍珠岩、立体网状纤维及脱硝功能微生物等复合而成，粒径书12mm×20mm，自然堆积密度（471±0．8）kg／m2，持水量（49±1．3）％，比表面积3．91m2／g，平均机械强度（427．3±0．2）N，pH为10．5-0．2。填料能长期在潮湿环境中保持良好的粘结强度，并具有营养缓释及pH缓冲能力。包埋脱硝功能微生物复合填料中初期微生物数量5．3×10^5 CFU／g，运行60d后微生物数量达到8．6×10 8 CFU／g，闲置停运30d微生物有所减少，但重启后净化效率基本不变。当进气负荷低于I878mg／（13m3·h），气体停留时间为14．47s时，BF，的去除率高达93．15％。     

MCM-41介孔分子筛的合成及其对铜离子的吸附性能简

以微硅粉为硅源，CTAB和PEG-6000为模板剂，合成MCM-41介孔分子筛。采用XRD、N₂吸附-脱附曲线、FTIR以及TEM表征了其结构、比表面积、孔径分布及晶体形貌，并且以该样品为吸附剂，对含Cu²⁺的溶液进行了静态吸附实验。结果表明，以微硅粉为硅源成功合成了具有典型六方排列孔道结构的MCM-41，其比表面积为869.5 m²/g，孔容为0.97 cm³/g，平均孔径为3.3 nm；溶液pH为5~6时，MCM-41对Cu²⁺的去除效果最好；MCM-41对Cu²⁺的最大吸附吸附容量36.3 mg/g；MCM-41对Cu²⁺的吸附性能符合Langmuir吸附方程的特征。动力学研究表明，该过程符合准二级动力学模型。     

介质阻挡放电协同Ag/Al_2O_3对NO_x脱除的影响

为有效去除发电厂烟气中产生的NOx,利用介质阻挡放电(DBD)产生低温等离子体并结合催化剂Ag/Al2O3进行烟气脱硝实验,研究了在加入乙烯的条件下,平均负载量、催化温度和装置的布置方式对NOx脱除的影响。结果表明,随着负载的增多,NO脱除率呈现先增大后减小的趋势,5种负载量中最佳为1.76%;随着催化温度的升高,NO脱除率同样呈现先增大后减小的趋势,最佳的催化温度为150℃左右;3种不同布置方式对NO和NOx脱除有明显差别,单独催化剂在NO和NOx的脱除率都比较低;单独介质阻挡放电NO脱除率很高,但是NOx很却很低;而两者结合在NO和NOx都达到了很好的效果。     

Chemical and process mineralogical characterizations of spent lithium-ion batteries: An approach by multi-analytical techniques

Mineral processing operation is a critical step in any recycling process to realize liberation, separation and concentration of the target parts. Developing effective recycling methods to recover all the valuable parts from spent lithium-ion batteries is in great necessity. The aim of this study is to carefully undertake chemical and process mineralogical characterizations of spent lithium-ion batteries by coupling several analytical techniques to provide basic information for the researches on effective mechanical crushing and separation methods in recycling process. The results show that the grade of Co, Cu and Al is fairly high in spent lithium ion batteries and up to 17.62 wt.%, 7.17 wt.% and 21.60 wt.%. Spent lithium-ion batteries have good selective crushing property, the crushed products could be divided into three parts, they are Al-enriched fraction (+2 mm), Cu and Al-enriched fraction (?2 + 0.25 mm) and Co and graphite-enriched fraction (?0.25 mm). The mineral phase and chemical state analysis reveal the electrode materials recovered from ?0.25 mm size fraction keep the original crystal forms and chemical states in lithium-ion batteries, but the surface of the powders has been coated by a certain kind of hydrocarbon. Based on these results a flowsheet to recycle spent LiBs is proposed.